CrimeStopper FS-99 Guía de instalación descargar pdf (Pagina 9)

WIRING: 18-PIN Connector Cont.

BLUE/WHITE: (-) 500mA Remote Aux. Output 2 (Programmable Option #11)

This is a programmable output that can operate 4 different ways.

1. Channel 2 = 2

Unlock Hold 2 Sec. - Default. Hold Unlock Button for 2 seconds to unlock passenger doors.

2. Channel 2 = 2

Unlock Double Press. Press Unlock button 2 times to unlock passenger doors.

3. Channel 2 = Momentary Hold. This is a momentary output as long as the remote button is pressed.

4. Channel 2 = 30 Second Timer.

BLACK/WHITE: (-) 500mA Remote Aux. Output 3 (Programmable Option #12)

This is a programmable output that can operate 4 different ways.

Channel 3 = Dome Light - Default. For Dome light Supervision with unlock.

Negative Dome Light System: Connects to terminal 85 of a relay. Connect terminal 86 to +12V Constant.

Connect terminal 87 to Chassis Ground. Connect Terminal 30 to the Negative dome light activation circuit.

Positive Dome Light System: Connects to terminal 85 of a relay. Connect terminals 86 & 87 to +12V Constant.

Connect terminal 30 to the Positive dome light activation circuit.

BROWN/WHITE: (-) 500mA Remote Aux. Output 4 (Programmable Option #13)

This is a programmable output that can operate 4 different ways.

Channel 4 = Horn Honk - Default. Connect to the Negative Horn Trigger wire usually located near the steering

column. If the vehicle horn circuit requires +12 volts, a relay is required. RELAY WIRING: Connect the Brown/White

wire to terminal 85, connect relay terminals 86 and 87 to +12V constant power. Connect terminal 30 of the relay to

the +12V positive device/circuit to be activated.

ORANGE WHITE: (-) 500mA Remote Aux. Output 5 – ACCESSORY or OEM REARM

(Programmable Option #14)

This is a programmable output that can operate 4 different ways.

Channel 5 = Accessory - Default. Controls 2

Accessory Output for Remote Start. RELAY WIRING: Connect the

Orange/White wire to terminal 85, connect relay terminals 86 and 87 to +12V constant power. Connect terminal 30

of the relay to the 2

Accessory wire of the vehicle. Channel # 5 can be programmed for OEM REARM. This

option provides a ground pulse to rearm the vehicles' FACTORY anti-theft system after a timed-out or aborted

remote start. Connect this wire to the vehicles' anti-theft rearm wire or to the door pin circuit depending on your

requirements. This wire may be needed to pulse the door pin circuit on vehicles with retained accessory power.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Sin comentarios

CrimeStopper FS-99 Guía de instalación Pagina 9