CrimeStopper FS-99 Guía de instalación descargar pdf (Pagina 13)

WIRING: 4-PIN Shock Sensor (22 Gauge wires)

SHOCK SENSOR: There are 2 sensor ports (zone 2 and 3) on the alarm module. The sensor supplied with this

system does not require any additional wiring. Simply mount the sensor in a suitable location. It can be tie wrapped

to a cable harness or mounted to a plastic panel. Plug sensor into Sensor Plug # 1 for zone 2, and adjust the

sensitivity. There are 2 LED’s on the shock sensor to assist you in adjusting sensitivity. The Green LED indicates

the “Warn Away” level and the Red LED indicates a full alarm shock sensor violation.

The adjustment knob next to Red LED is for trigger.

The adjustment knob next to Green LED is for Pre-Warning.

Antenna Plug

Valet Plug

LED Plug

Sensor Plug # 1

Sensor Plug # 2

MAIN MODULE

(Zone # 2)

(Zone # 3)

Data Plug (Bypass Module)

Smart Phone

Data Plug

The Sensor Plug #2 is zone 3 for an optional sensor.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Sin comentarios

CrimeStopper FS-99 Guía de instalación Pagina 13