CrimeStopper FS-99 Guía de instalación descargar pdf (Pagina 10)

WIRING: 18-PIN Connector Cont.

BLUE/BLACK: (-) 500mA Remote Aux. Output 6 (Programmable Option #15)

This is a programmable output that can operate 4 different ways.

Channel 6 = Ignition Run - Default. This is used for Remote Start - Ground when Running. This wire functions as

a Negative IGNITION OUTPUT (Ground while Remote Starting) for use when connecting factory Security Bypass

modules or when an additional external Ignition Relay is required for your installation.

BLACK: CHASSIC GROUND

Connect to body metal of the vehicle using a sheet metal screw and a star washer to ensure a good ground. Keep

the Ground wire short. Scrape away paint or debris from ground location.

GRAY: (-) Hood Trigger and Temperature Sensor Input – Zone # 6

Input trigger for a grounding hood pin switch. Connect to an existing hood pin switch that read ground when open. If

no existing switches are available, install new pin switches if desired. Note: DO NOT mount new pin switches in

water pathways.

Locate Temperature Sensor inside vehicle out of direct sunlight. The Temperature Sensor connects to Gray Hood

switch input as shown.

(-) Hood

Switch

Temperature Sensor

Gray Wire

Alarm Plug

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Sin comentarios

CrimeStopper FS-99 Guía de instalación Pagina 10