16
Remote Engine Starting:
Press and hold the Remote Start Icon until the remote control beeps a 2
nd
time.
1) Parking lights flash twice and the system will chirp 3 times for audible confirmation.
The 2-Way LCD Pager will give voice confirmation “Engine ON”.
2) After the Ignition and Accessory circuits turn for a few seconds, the Starter Motor
engages.
3) After Engine Starts and Runs, the Parking Lights flash 3 times. The 2-Way LCD
Pager will give voice confirmation “Car Started”.
4) The Touch Screen will show the Engine RUN Time Countdown every minute.
5) Engine will remain running for programmed run time until reset with Brake pedal. The
system will chirp 4 times with Brake Reset. If needed, the engine can be turned off
with remote transmitter. The 2-Way Pager will give voice confirmation “Engine OFF”.
Notes:
• The remote will display an Icon while vehicle is running.
• The system will attempt to Remote Start 4 times.
• The Chirps with Remote Start can be programmed ON or OFF.
• The Door Locks are programmable ON or OFF with Remote Start.
• If vehicle doesn’t remote start, the system has onboard LED Diagnostics.
MANUAL TRANSMISSION EXIT PROCEDURE (Option #26-2 and 26-3)
This system features a Manual Transmission Mode. When exiting the vehicle, there is safety
check out procedure required for the manual transmission mode to work. There are 2
choices of operation,
1. Option 26-2: With engine running and vehicle in neutral, set parking brake, then
press “Idle Down” Icon or remote start on transmitter. The remote starter will turn on
and take over operation of the vehicle.
2. Option 26-3: With engine running and vehicle in neutral, set parking brake. The
remote starter will turn on and take over operation of the vehicle.
3. Remove key, exit vehicle (remote starter unit must “SEE” door opened, then closed
with engine running).
4. Press Lock button within 10 seconds of closing door to Arm system with “Idle Down”
(engine stays running). Press Lock a 2
nd
time to cancel “Idle Down” (engine turns off)
and set up Manual Transmission Mode.
5. Press Lock button after 10 seconds of closing door to Arm system, lock the doors and
shut down the engine. From this point, the system will remote start the engine unless
a door is opened or the alarm is triggered (either function will cancel the remote start
sequence).
6. Option 26-4: With engine running and vehicle in neutral, set parking brake, the
remote starter will turn on and take over operation of the vehicle. Remove Key and
exit vehicle. When the last door of vehicle is closed, the engine will turn off in 2
seconds and set up Manual Transmission Mode. You can arm the alarm system to
lock doors and protect vehicle
(14 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales