CrimeStopper FS-89 Instrucciones de operaciones descargar pdf (Pagina 10)

Pre-Warning Shock Protection:

The Pre-Warning (Warn-A-Way) feature will activate when a low-level Light Shock or

vibration is detected by the system’s shock sensor. The alarm will chirp the siren 6 times to

help deter any further tampering with the vehicle. You will receive a paging signal that will

display an icon of a hammer hitting the vehicle. The 2-Way LCD Pager will also vibrate and

give voice confirmation of “Sensor Warning” to notify you the vehicle has been tampered

with. The Pre-Warning is Bypassed after 5 cycles and reinstated after 10 minutes with

no activity. There is 2

Sensor circuit with Pre-Warning and full alarm trigger. This is for an

optional microwave (radar) or glass break sensor. Both sensor zones are independently

monitored.

Alarm Triggers:

If there is an intrusion into the vehicle, a hard impact to the body or the

ignition is turned on; the alarm will sound and flash the lights for 30

seconds. If you are within range, you will receive a paging signal that

will display an icon of what caused the zone violation. The 2-Way LCD

Pager will also vibrate and give voice confirmation of “Door, Hood,

Trunk, Ignition or Sensor Trigger” to notify you the vehicle has been tampered with. If a

door is left open after an intrusion then the system will cycle once and bypass the door. If

any individual zone is triggered 5 times in one arming period, it will be bypassed. The

system will continue to protect the other un-tampered or unopened zones.

Prior intrusion Alert:

This system will notify you if the alarm was triggered while you were away. Upon disarming,

there will be four siren chirps instead of the two normal disarm chirps. Check your vehicle for

any signs of a break in or tampering. The Blue Status LED will flash the trigger zone number

as follows:

2 LED Flashes = Sensor # 1

3 LED Flashes = Sensor # 2

4 LED Flashes = Trunk

5 LED Flashes = Door

6 LED Flashes = Hood

7 LED Flashes = Ignition

Diagnostics will reset when the Ignition is turned on or when the system is re-armed.

Alarm Trigger History:

The LCD remote will keep a detailed record of the trigger zone, time

and date and vehicle number. The Touch Screen shows the CAR # on

the bottom of display. Press the Icon to change the

Trigger History Display from CAR 1, 2, 3 or 4.

The Sensor Trigger is Bypassed after

4 cycles and reinstated after 1 hour.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Sin comentarios

CrimeStopper FS-89 Instrucciones de operaciones Pagina 10