CrimeStopper TN-4003 Manual de instrucciones descargar pdf (Pagina 9)

WIRING

NOTE: Some Options Need to Be Pre-programmed From Crimestopper prior to

installing the unit.

Pin 1 Black: Chassis Ground Input

THIS WIRE MUST BE CONNECTED TO THE CHASSIS METAL OF THE VEHICLE.

Scrape away any paint or dirt to ensure a good connection.

Pin 2 Green: Starter Disable (-) (Output #2) Requires Relay

This wire has a negative output to hook up to optional relay. See wiring diagram for

connection.

Pin 3 Blue: GEO Fence (Optional) (-) Input #2

Connect wire to momentary switch 2 sec input to trigger for GEO fence or 15 sec

input to trigger alarm.

Pin 4: Empty

Pin 5 Red: Battery Back Up Power (Input)

Pre-wired to connector for battery back up.

Pin 6 White: Overheat Trigger/ Road Side Assistance (-) Input #3

This wire needs 2 minute trigger for Overheat or 2 sec trigger for Road Side

Assistance. Pre-programmed for Overheat.

Pin 7: Empty

Pin 8 Brown: Ignition Input #4 (+)

This wire must be connected to an Ignition source.

Pin 9: Empty

Pin 10 Purple: LED (Optional) (+) Output

This wire connects to optional LED for visual status of RSA or GEO Fence.

Pin 11 Yellow: Door Unlock Output (-)

This wire connects to the door unlock circuit. This wire is a negative output and may

require additional relays to interface with different door lock circuits

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

CrimeStopper TN-4003 Manual de instrucciones Pagina 9