CrimeStopper CS-9704 Manual de usuario

CS-9704RS INTEGRATED ALARM/REMOTE START SYSTEM INSTALLATION / OPERATING MANUAL INTRODUCTION: This is a combination vehicle security alarm

This feature controls the length of time the starter stays engaged. If the default (0.8 seconds) is not long enough to start the engine, change the s

UNIT SHUTS DOWN 4-5 SECONDS AFTER REMOTE STARTING: The unit does not sense the engine in Tachless mode. Turn dip switch #4 OFF and wrap the gray wire

IGNITION 1IGNITION 1ACC/IGN 2BATTERYSTARTER+BRAKE SWITCH(-) HOOD /TRUNK SWITCH(+) DOOR SWITCHYELLOWIGNITIONSWITCHVIOLETGREENBLUE30AMP20AMP10AMPFUSEFUS

INSTALLATION CAUTIONS & WARNINGS 1. BEFORE BEGINNING, check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAG

WIRING J-1 6 PIN HI-CURRENT CONNECTORS (See Wire diagram at back of manual for Details) RED: +12V INPUT RED: +12V INPUT (30 Amp) BROWN:

WIRING GRAY WIRE: PIN 6: Engine Monitor (used for tach mode only) Used to monitor when the engine is running. Connect to negative terminal of igni

WIRING J-3 2 PIN PLUG (WHITE) RED-BLACK WIRE: PIN 1: DOME LIGHT ILLUMINATION (-) (REQUIRES RELAY) Connect to terminal 85 of relay. This wire tu

This system performs the following tasks by pressing one of the buttons on the hand-held transmitter: • ARM / LOCK • DISARM / UNLOCK • TRUNK P

REMOTE ENGINE START: Press and hold the Remote Start button on the transmitter until you hear 3 siren chirps (release button) then the parking lights

ACTIVE RE-ARMING: Active Re-arming means that the system will re-arm itself 30 seconds after disarmed with the transmitter if a door has not been open

9To eliminate siren chirps, turn the ignition on and press the transmitter’s remote start button for about 3 seconds. You will hear a short double c